Solved Form C contact in auxiliary contact list showing as splitted NO
Form C Contact. 2 form c (2 co) signal relay contact switching voltage (max)(vac): Web form c contacts (change over or transfer contacts) are composed of a normally closed contact pair and a normally open contact pair that are operated by the same device;
Form y = nc with both terminals disconnected when off. Form c is a combination. This type of contact controls two circuits: Web form c contacts (change over or transfer contacts) are composed of a normally closed contact pair and a normally open contact pair that are operated by the same device; 2 form c (2 co) signal relay contact switching voltage (max)(vac): A form c contact is also called spdt. Web a form c reed switch is essentially a single pole double throw reed switch. These contacts have a common terminal. Web a “ form c ” would have 3 leads and would have 1 normally open and 1 normally closed circuit. This is caused by the magnetic field produced by a coil or the magnetic field from a magnet.
This is also called a “changeover” device because the common contact changes from the normally closed position to the normally open position when the coil is energized in a relay or a magnetic field is nearby in a reed switch. There is a common electrical connection between a contact of each pair that results in only three connection terminals. They can be part of any type of a relay or auxiliary switch. Web form c is one normally open contact and one normally closed contact with a common terminal between them. One normally open and one normally closed. 2 form c (2 co) signal relay contact switching voltage (max)(vac): These contacts have a common terminal. This is caused by the magnetic field produced by a coil or the magnetic field from a magnet. A form c contact is also called spdt. Web a dry contact is one that is a hard contact such as a relay or switch (as opposed to a triac or transistor). Web a single form c contact isn’t much good unless you are trying to design a system whose pl only requires pl a or pl b, but adding a second contact to this device adds the possibility of monitoring the relay.
